【Material】：SS304 Stainless steel
【Price】：$190.00 - $890.00
+86 18221614363
digital turbine flowmeter oil turbine flow meter fuel,turbine air flow meter,gas turbine flow meter,insertion turbine flow meter,turbine flow meter price
The vortex flowmeter is a flowmeter that uses the Karman vortex principle. It is used to measure the flow of liquids, gases and steam. It can also measure turbid liquids containing tiny particles and impurities. It is widely used in petroleum, chemical, pharmaceutical, papermaking, Metallurgy, electric power, environmental protection, food and other industries.
·High-strength piezoelectric crystal, one-piece molding, impact resistance
· Compatible with liquid, gas, heat transfer oil and steam metering
·Sonic nozzle calibration, high repeatability, high measurement accuracy
·The temperature compensation, pressure temperature can be freely selected to meet more on-site use
·The circuit board is aging and running before leaving the factory, and the whole meter is calibrated one by one, which is more suitable for on-site use
·Sensing head has anti-vibration and anti-interference packaging technology, stronger on-site anti-interference
·Ultra-high temperature resistance can reach 420℃
Product name: Intelligent anti-vibration vortex flowmeter
Measuring medium: gas, liquid, steam, heat transfer oil
Nominal diameter: DN15-DN300
Output signal: voltage frequency pulse, 4~20mA signal
Communication mode: RS485, HART optional
Working power supply: 24VDC±5%, lithium battery 3.6VDC
Nominal pressure: flange card mounting type (2.5MPa)
Flange connection type (1.0/1.6/2.5MPa)
Accuracy level: 1.5 (gas), 1.0 (liquid)
Medium temperature: -40℃~+260℃, -40℃~+420℃
Protection level: IP65
Correct product selection and installation can increase on-site measurement accuracy and prolong the service life of the instrument → please consult for details
This product is suitable for non-explosion-proof occasions, if explosion-proof products are required, special note
l Installation site and environment selection
1. Try to avoid strong power equipment, high frequency frequency conversion equipment, and strong power switch equipment;
2. Try to avoid the influence of high temperature heat source and radiant heat source; outdoor installation should take measures to prevent rain and shade;
3. Avoid vibrating places and strong corrosive environments as much as possible; at the same time, it is necessary to consider the convenience of installation and maintenance;
l Reasonable and correct installation location
1. Try to avoid choosing pipes with strong vibration at the installation location, otherwise, vibration damping measures must be taken, such as installing damping sub-sections;
2. The flowmeter can be installed horizontally, vertically and inclinedly. When measuring liquid, you must ensure that the fluid flows from low to high;
When measuring gas, the flow direction is not limited;
When measuring steam or high-temperature gas, the pillars of the meter body should be installed at an angle of 45° from the vertical as far as possible;
l Straight pipe section requirements
In order to accurately measure, there must be enough straight pipe sections upstream and downstream of the flowmeter, and there should be no components that affect the flow rate distribution of the fluid upstream.
l Grounding requirements
When the flowmeter is installed, the meter body should be reliably grounded. If the on-site pipeline does not have the grounding conditions, a separate reliable ground wire should be made to connect to the ground terminal of the meter shell.
